This property corresponds to the IJWeldingSymbol property. You cannot configure it using the Symbol Configuration tab.
Primary Side Symbol
Specifies the drawing symbol to use on the primary side. The software sets this property only for cases where there is a fillet weld (Lap and Tee only).
Secondary Side Symbol
Specifies the drawing symbol to use on the secondary side. The software sets this value only for cases where there is a fillet weld (Lap and Tee only).
Primary Side Groove
Specifies the type of groove on the primary side (None, Square, V, Bevel). For the types that can have a bevel (Bevel or V) on this side, the software makes the choice between bevel or none by the presence of a non-zero bevel depth.
Secondary Side Groove
Specifies the type of groove on the primary side (None, Square, V, Bevel). For types that may have a bevel (Bevel or V) on this side, the software chooses between bevel or none by the presence of a non-zero bevel depth.