-
Click Select
on the vertical toolbar.
-
Set the Locate Filter to Wall Systems.
-
Select the wall to which to add the fillet corner.
-
Click Select a Path
on the Place Wall Ribbon.
-
Click Sketch 2D
on the ribbon.
-
Click Draw
.
-
Click Fillet
on the vertical toolbar.
-
Place the fillet on the wall path by identifying the two sides for the fillet and then the radius.
-
Click Add or remove graphic from a group
on the Change toolbar.
-
Click Select Graphic Group
on the ribbon.
-
Select the original wall path. Be sure to use the Bottom Up
option during selection.
-
Click Select elements to add to group or remove from it
on the ribbon.
-
Select the fillet segment of the wall path that you just placed. Be sure to use the Bottom Up
option during selection.
-
Click Add
on the ribbon.
-
In the 2-D environment, click Close
.
-
Click Finish.
-
Set the wall system, type, composition, and other properties.
-
Optionally, click Select Boundaries
to limit the height of the wall.
-
Click Finish to place the fillet in the wall.
