-
In the Grids task, create grids as needed for drawing the trench path.
-
In the Civil task, click Place Trench Command .
-
Click Path on the Place Trench Ribbon, and define the path of the top of the trench.
-
Select a cardinal point at the top of the trench: Top Left , Top Center , or Top Right .
-
Select Define start depth and bottom slope as the placement method.
-
Select the parent system of the trench run.
-
Select a trench type and its respective cross-section.
The start depth is defined by the Catalog during placement. You can modify this after placement. See Modify a trench feature.
-
Type a value for Bottom Slope.
-
Click Finish to create the trench. An example trench elevation is shown below.
1 - Drawn trench path with varying global Z-coordinates along the path
2 - Defined top cardinal point for cross-section
3 - Defined start depth from trench cross-section
4 - Defined slope
5 - Defined footing thickness from trench cross-section
6, 7, 8 - Trench depths computed by (global Z-coordinate of drawn path) - (invert elevation)