Use the Buffer to Scope Items - Intergraph Smart P&ID - 11.0 - Administration & Configuration - Intergraph

The buffer in the Project Management table allows you to make a preliminary selection of items that you want to scope.

1. With the Project Management table in an As-Built plant open, right-click in the Project Management table and then select Show/Hide Buffer, or select .

2. Drag the required items one-by-one to the buffer in the Project Management table. You can drag items from any of the following:

   • Electrical Index

   • Electrical Engineer

   • EDE

   • a schematic

   • a single line diagram

3. In the Buffer, select the check boxes next to the items that you want to scope.

4. Select on the Project Management toolbar or right-click in the Project Management table and then select Paste from Buffer.