-
Plnt (Column A) - It defines the set of table entries for a specific Maintenance plant:
-
If this column has any SAP Maintenance plant value, the parameter values are applicable only to a specific plant.
-
If this column has no value, the parameter values are applicable to all Maintenance plants.
-
-
APP_LOG (Row 2) - It is required only when you use the Equipment installation/replacement/dismantle functionality. The parameter value can be ‘X’ or empty:
-
If the value is ‘X’, the Equipment installation/replacement/dismantle functionality is configured, and the logs are written on your plant. We recommend you remove ‘X’ when the configuration and setup are complete because it consumes a lot of memory.
-
If the value is empty, the Equipment installation/replacement/dismantle functionality is not used, and no logging for this functionality is active.
-
-
ASSET_CONV (Row 3) - It defines how Equipment numbers are handled for the Equipment installation/replacement/dismantle and Jump interface functionalities. The parameter value can be ‘X’ or empty:
-
If the value is ‘X’, the Equipment number is handled without leading zeros.
-
If the value is empty, the Equipment number is handled with leading zeros.
-
When you want to use the Asset to Equipment sync functionality, you must sync Asset to Equipment from SDx in the same way as defined in this table. Make sure that the leading zeros section of your XSLT file is updated based on your system requirements.
-
-
SCOPEMAP (Row 11) - It defines a plant mapping table used for mapping. The value can either be ‘X’ or empty:
-
If the value is ‘X’, the /INGR/SCOPEMAP_V table is used for mapping.
-
If the value is empty, the /INGR/PLNTMAPP_V table is used for mapping.
-
If this entry does not exist in the table (for existing customers), the /INGR/PLNTMAPP_V table is used for mapping.
-