The system shows all of the parts associated as standards on the Standards Used form. Enter new standards for the calibration as necessary.
To enter calibration standards:
-
Select Work > Work Order.
-
Select the work order for which to enter calibration standards, and then click the Calibration tab.
-
Click the Calibration Standards tab.
-
Click New Record.
The Part and Equip lookups show data that is in the current work order's organization and the common organizations for which you have access permission.
-
Specify this information:
Part - Specify the part used as the standard.
Asset - Specify the equipment associated with the part. Enter the equipment associated with the part for parts tracked by asset. If the part is tracked by lot, you can only select equipment belonging to the same lot of the part.
Equip - If the selected work order is a multiple equipment work order, you can Specify standards for all equipment, work order header equipment, or one piece of equipment.
Lot - Specify the lot for the part used as the standard.
-
Click Save.
-
Click Yes.