Preferences - CloudWorx for Intergraph Smart Review - Help

CloudWorx for SmartPlant Review Installation and Help

PPMProduct
CloudWorx for Intergraph Smart Review
aSubProduct
CloudWorx for SmartPlant Review
PPMCategory_custom
Help
Version_SThreeD_Custom
12 (2018)
Version_SPR
13.x(2018)

Accessories > CloudWorx > Preferences

Allows you to modify CloudWorx settings listed below.

Cloud Display Tab

Provides options for specifying the point thickness and interference point thickness.

Point Thickness - Type a value in pixels for the width of each point in a point cloud display.

Interference Point Thickness - Type a value in pixels for the width of each point in an interference check display.

Pick/Visible Tab

Provides options to show or hide cloud points and snap-to operations.

Hide All Cloud Points - Toggles the overall visibility of point clouds. Points can also be hidden by the limit box, hidden regions slice, and section.

Disable Snap On Cloud Points - Toggles the ability to select point clouds.

Load Control Tab

Provides options to set load limit, display limit, dynamic display limit, and computation limit.

Used to set the maximum number of points loaded by CloudWorx. This performance setting is to protect CloudWorx from running out of memory. Performance is related to the computer speed and memory capacity. If the current viewport setting requires more points than the load limit, CloudWorx reduces the level of detail to comply with the limit.

When this command is used while a ModelSpace View is open, it might affect the next Regenerate Points command only if the loading limit is met. The typical setting for a 2 GHZ+ CPU with 1GB memory is 8 (million). Do not use a setting less than 2.

Load limit - Type a value for the load limit in million points.

Display limit - Type a value for the display limit in million points.

Dynamic display limit - Type a value for the dynamic display limit in million points.

Computation limit - Type a value for the computation limit in million points.