Scenario 3: Use a Quick LImit Box tool - CloudWorx for Intergraph Smart Review - Help

CloudWorx for SmartPlant Review Installation and Help

PPMProduct
CloudWorx for Intergraph Smart Review
aSubProduct
CloudWorx for SmartPlant Review
PPMCategory_custom
Help
Version_SThreeD_Custom
12 (2018)
Version_SPR
13.x(2018)

Use a limit box as a clipping tool to work with a small area of points. The Quick Limit Box tool uses a single selection in the TruSpace viewer to define the center of the area in which to work. A limit box is applied with a pre-defined size around that center.

  1. Open a TruSpace viewer from which the region of interest is visible.

  2. Enable Quick Limit Box.

  3. Adjust the range of the Quick Limit Box.

  4. In TruSpace, switch to the Quick Limit Box mode

  5. In the TruSpace viewer, select the required center point.

    The CAD viewports are updated with the corresponding limit box.

  6. Click Accessories > CloudWorx > Regenerate Point Clouds to load more points for the viewport and get more details.

  7. Click Accessories > CloudWorx > Reset Clipping to disable limit box clipping.