Specifies the following terms for each component type:
Forged Tee to BS 1640
Typical units (depending on your unit system):
-
in
-
mm
-
cm
Specifies the T value. For more information on T, see IGE\TD\12 Reference.
Weldolet
Specifies the theta (q) value in degrees. For more information on theta, see IGE\TD\12 Reference.
Drawn/Extruded Tee
Typical units (depending on your unit system):
-
in
-
mm
-
cm
Specifies the T value. For more information on T, see IGE\TD\12 Reference.
Weldoflange
Specifies the theta (q) value in degrees. For more information on theta, see IGE\TD\12 Reference.