Miter and Coping
Auto Miter
Miters two structural pieces to fit each other. The two structural pieces must be in the same plane and have connected member ends. You miter multiple member pairs in each command pass. For more information, see Auto Miter.
Auto Cope
Copes members to other members. You can place bolted coping or welded coping. You can turn on both Bolted and Welded, and the software prompts you to select an option when coping. If you turn on only one of the coping options, the software does not prompt you and automatically copes your members based on the selection and the Cope Distance set for that selection. For more information, see Auto Cope.
-
Bolted Coping
Copes the members with the offset specified by Cope Distance.
-
Cope Distance
Specifies the distance between the coped member and the primary boundary member.
-
Welded Coping
Copes the members with the offset specified by Cope Distance.
-
Cope Distance
Specifies the distance between the coped member and the primary boundary member.
Bracing
Auto Bracing Work Point Offset
Automatically offsets your bracing to half the beam depth not to exceed the value set in Max Work Point Offset when placing vertical bracing.
Max Work Point Offset
Specifies the maximum offset distance at the end points of the vertical bracing member.
Apply Change Data
Allows you to select which content does not update when you edit a member or when SPRJCONVERT is applied:
-
Custom Data
-
Long description
-
Short Description
-
Tag
-
Part Number
-
Material
-
Layer
-
Color
Synchronize with external database
Controls the synchronize option on opening a drawing with an external database:
Turn Off Synchronize
Turns off the synchronize option when a drawing is loaded into CADWorx.
Synchronize With Prompt
Asks if the software should synchronize the drawing with the external database.
Synchronize Without Prompt
Synchronizes the drawing with the external database without prompting.
Synchronize With Changes Review
Enables you to review the changes made to the database and accept or reject the changes as needed.
When you click Sync DB 
, values Turn Off Synchronize and Synchronize With Prompt provide a prompt. Synchronize Without Prompt synchronizes without any prompts. Synchronize With Changes Review displays the Synchronize Component dialog box where you can decide which information you want to update to your drawing
from the database.