Drawing a Stub with a stub-end or adapter lap end type set - CADWorx - Help

CADWorx Spec Editor

PPMProduct
CADWorx
PPMCategory_custom
Help
Version_CADWorx
20.1 (2020 R1)
  1. Double-click a specification.

  2. Right-click the Main Spec List View, and then select Add.

    The New component pane displays.

  3. Select Flanges from the Groups list.

  4. Select Flanges from the Category list.

  5. Select Stub from the Type list.

  6. Select a stub data table from the Data Table list.

  7. Click the Start list and expand the Stub End end type.

  8. Double-click the Stub End end type.

    You must create the stub end end type using the New End Type option. For more information, see Create a Stub End end type.

  9. Select a lap joint flange from the Backing Flange list.

  10. Click Add.

  11. Click File > Save.

  12. Launch CADWorx Plant.

  13. Start a new drawing.

  14. Click Setup .

  15. Click Specification / Size.

  16. Click Browse and select the project (.prj) containing the Stub component.

  17. Click Open.

  18. Click Spec View .

  19. Click + to expand Flanges.

  20. Click the stub component.

  21. Place the stub component in the drawing.

    The component displays with the lap joint attached as shown below: