Drawing a Stub without an end type set - CADWorx - Help

CADWorx Spec Editor

20.1 (2020 R1)
  1. Double-click a specification.

  2. Right-click the Main Spec List View, and then select Add.

    The New component pane displays.

  3. Select Flanges from the Groups list.

  4. Select Flanges from the Category list.

  5. Select Stub from the Type list.

  6. Select a stub data table from the Data Table list.

  7. Click Add.

  8. Click File > Save.

  9. Launch CADWorx Plant.

  10. Start a new drawing or open an existing drawing.

  11. Click Setup .

  12. Click Specification / Size.

  13. Click Browse and select the project (.prj) containing the stub component.

  14. Click Open.

  15. Click Spec View .

  16. Click + to expand Flanges.

  17. Click the stub component.

  18. Place the stub component in the drawing.

    The component displays in the drawing as shown below:

See Drawing a Stub with a stub-end or adapter lap end type set.