Use this option when you want to change the size of more than one reducer and the
pipe lines to multiple sizes.
-
Click Change Size
. Alternatively, type CHANGESIZE on the command line, and press ENTER.
-
Type M for manual.
-
Select one or more reducers and press ENTER.
If you select more than one you might not be prompted for the sides of the reducer.
This depends on the location of the chosen reducers.
-
If applicable, type Large, Small, or Both on the command line, and then press ENTER.
-
Select a size from the list. This list continues to show up for as many components as you selected.
If a size is not available in the catalog for a component the process stops, forcing
you to start over.
-
Select a component to keep its position, or press ENTER to finish.
Until you press ENTER to finish the software continues to prompt you for selection
of a component.
The selected components change size.
If you change the size of a pipe on the small end of a reducer to the same size as
the pipe on the large end of the reducer, the software gives you the option to change
the component. If you do not change the component the process fails.