Thrd/SW Ecc Swage - CADWorx - Help

CADWorx Plant

Language
English
Product
CADWorx
Subproduct
Plant
Search by Category
Help
CAESAR II Version
12
I-Configure Version
6.0(2016)
Smart Isometrics Version
8
Spoolgen Version
10
CADWorx Version
20.1 (2020 R1)
CADWorx Structure Version
2020 R1 (4.1)

Thrd/SW Fittings toolbar: Thrd/SW Ecc Swage

Command line: SWGE

Places an eccentric reducer swage in the X-Y plane.

last point

Starts the component at the last point of the previously-created component.

Large end

Places the non-reducing end at the start point.

Small end

Places the reducing end at the start point.

Large end type

Specifies the end type connection at the large end of the swage.

Small end type

Specifies the end type connection at the small end of the swage.

Up

Places the flat side of the reducer in the positive Z direction.

Down

Places the flat side of the reducer in the negative Z direction.

This command reverses the main and reduction sizes automatically after execution.