CADWorx Plant tab: Pipe Router > Threaded
Plant Menu: Accessory > Auto Route > Threaded
Command line: ROUTETHRD
Draws threaded pipe.
Elbows only
Draws only elbows on a particular pipe run.
Pick points
Draws pipe and elbows on a particular pipe run. The software first prompts you to select a starting point. Afterwards, you select a location point for each elbow you want to place, followed by an ending location. Press ENTER to finish the command. Pipe and elbows are drawn along each construction point.
-
An elbow is not placed at the starting and ending locations.
-
The Elbows only and Pick points options allow you to select location points only, not polylines.
Select polyline
Builds pipe and elbows based on polyline selection. This option also provides rolling offsets.
For information on 3D polyline construction, see Router.