-
Select a reducer in a drawing.
-
Press DELETE.
The software highlights the line on the reducing (small size) side of the reducer, and then prompts you to change the size of the line.
-
P&ID wont update the line after deleting a reducer if the reducer is within the tolerance of a valve.
-
To change the size of the opposite side of the line, click OppositeSide; the software highlights the line on the other side of the reducer.
For example, to change the size of the entire line to two inches, do the following:
-
Click OppositeSide, and then click Yes to change the size to two inch.
-
Delete the other reducer, click OppositeSide, and then click Yes.
In the example below, we resized the line to a four inch line.
-
-
Click Yes.
The software changes the size of the line and any inline component along the line.
-
Double-click the line to verify the change.
-
Repeat the steps to delete the other reducer.